Radiolink F722 Flight Controller

Radiolink F722 Flight ControllerRadiolink F722 Flight Controller SpecificationsDimensionDimension30.5*30.5mm(1.2″*1.2″)Weight9.5gHardwareProcessorSTM32F722RET6SensorGyroICM42688BarometerBMP280/DPS310Blackbox128MB, record and store flight logsOSD ModuleAT7456EConnectorChannel OutputM1 – M8Video Transmissiontransmission plug-and-playTransmissiontransmission plug-and-playSoldering PadsSupportBattery Scale110UART Port5ESC FeaturesSupportI2CSupportLED StripSupport, with LED strip soldering padsBuzzerSupport, with buzzer soldering padsRSSI OutputSupport, with RSSI soldering padsFirmware TypeBetaflightFirmware NameRADIOLINKF722USB Port1 (Type-C)RC In Signal InputSBUS/CRSFOSD TelemetrySupport, OSD Module IntegratedESC ProtocolPWM, two-way DShot, and OneShot ProtocolInput Voltage3-6SBEC5V/3A; 12V/3A12V BEC SwitchSupport (USER1)Adaptable Models2-8 axis multi-rotor including X8 models, Airplane, A-tail Quad, Bicopter, Custom Airplane, Custom Tricopter, Dualcopter, Flying-wing, Gimbal, Helicopter120, HEL , HEX H, HEX X, OCTO FLAT , OCTO FLAT X, OCTO X8, OCTO X8 , PPM to Servo, Quad , Quad X, Quad X 1234, Singlecopter, Tricopter, V-tail Quad, Y4, Y6Operating Temperature-30~85°PackageLED IndicatorSoldering Pad DefinitionSocket Interface DefinitionFC & ESC ConnectionMethod 1: All connectorsNote: When two ESCs are connected in this method, please disconnect the BAT, CURR, TLM cables for one of the ESC.Method 2: Direct SolderingFC’s Peripheral ConnectionMethod 1: All connectorsMethod 2: Direct SolderingNote: when connecting DJI image transmission, the SBUS pin of DJI will occupy the R2 pin of F722. If DJI SBUS signal remote control is used, please disconnect the device on the R2 and T2 solder pad or on the receiver socket. If R2 and T2 solder pad or receiver socket are occupied to connect other receivers, please disconnect the DJI SBUS connection.FC Firmware UpdateLong-press the DFU button. At the same time, connect F722 to the computer with a USB cable. Betaflight Configurator will display the DFU mode (See picture below);Select RADIOLINKF722 and 4.5.1 firmware in Betaflight Configurator. Then click “Load Firmware [Online]”;After the firmware is loaded, click“Flash firmware”;After the firmware is flashed, connect it to Betaflight Configurator again. The icon of gyroscope, accelerometer, barometer and DataFlash will be displayed.Fimwares and more info If the above communication cannot solve your problem, you can also send emails to our technical support: [email protected]Thank you again for choosing the RadioLink product.Flight Controller for Drones | TechRoLK FPV Drone Store