AC Current Clamp Sensor 100A SCT-013-000 Non-invasive

DescriptionAC Current Clamp Sensor 100A SCT-013-000 Non-invasiveThis non-invasive current sensor clamped around the supply line can measure a load up to 100 Amps, and allow you to calculate how much current pass through it. It can be useful for building your own energy monitor or for building an over-current protection device for an AC load. This current clamp can be used to detect a current of up to 100A. Simply clip it around the current source that you wish to measure and it will produce a (very) small AC voltage proportional to the current. The cable is terminated on one end with a standard 3.5mm jack (like a headphone jack).Use this to build your own energy monitor and keep your power usage down, or use it to to build an over-current protection device for an AC load. See the link below for an example project. Check out the datasheet for the pinout of the 3.5mm jack.What is CT sensors: Current transformers (CTs) are sensors that are used for measuring alternating current. They are particularly useful for measuring whole building electricity consumption (or generation for that matter).The split core type such as the CT in the picture above, is particularly suitable for DIY use it can be clipped straight on to either the live or neutral wire coming into the building without having to do any high voltage electrical work.Applications:Suitable for the current measuringMonitoring and protection of AC motorLighting equipmentAir compressorSpecifications:Input Current: 0~100A ACOutput Mode: 0~50mANon-linearity: ±3%Turn Ratio: 100A:0.05AResistance Grade: Grade BWork Temperature: -25°C ~ 70°CLeading Wire in Length: 1mNon-invasive current transformerSuitable for lighting equipment, AC motors, air compressors, monitoring, current measurement, and protectionMeet UL94-V0 flame retardant propertiesTwo form of output current, voltage (voltage output built-in the sampling resistor)Non-linearity ±3%(10%-120% rated input current)Model: SCT-013-000Reference project: Open Energy MonitorCore Material: FerriteDielectric Strength: 6000V AC/1minInput Current: 0A-100AAnti-flaming rate: UL94-V0Mechanical strength: opening and closing times, no less than 1000 times (20 ℃)Opening Size: Approx. 0.51 * 0.51inch / 13 x 13mmTutorials:Current Monitoring with Non-Invasive Sensor and ArduinoCT sensors – An introduction